Hey, just a heads-up that this content is based on an automatically imported version from our old CMS. If the formatting isn’t perfect, I’m sorry about that.
Translation
This original post is written in german 🇩🇪, a rough Translation:
Game keeps crashing, girlfriend back in 3 hours, Vista acts up, so I’ll install the Windows 7 RC via USB. No DVD, my Corsair Voyager is faster anyway. Steps: use diskpart to clean, create primary partition, format FAT32 “Windows 7” quick, set active, exit.
Original German Content
So, aktuelles spiel schmiert eh ständig ab, Freundin kommt erst in 3h wieder Vista spackt sowieso rum also dann doch mal den Win7 RC installieren. Da ich gerade keinen DVD Rohling zur Hand habe muss das ganze per USB Stick gehen, da mein Corsair Voyager mit seinen 34M/s Leserate sowieso deutlich schneller ist muss er dafür herhalten. Während der Download der Windows7 RC ISO läuft kurz mal hier das Tutorial getippt.
USB Stick mit FAT32 versehen
Achtung ! Vorher alle Daten des Stick`s sichern - die sind weg nach dem Vorgang.
- USB Stick einstecken (bitte nicht an einen USB Hub sondern direkt am PC).
- Konsole Öffnen und diskpart.exe starten.
- Vorhandene Disks anzeigenlassen mit list disk
- USB Stick aus der Disk Liste wählen. Angenommen USB Stick wäre Disk3: sel dis 3
- USB Stick säubern durch Eingabe von clean
- Nun eine neue Primäre Partition erstellen: create part pri
- Und anschließend auswählen: sel part 1
- Nun diese Formatieren: format fs=fat32 LABEL=“Windows 7” QUICK OVERRIDE
- Danach die Partiton aktiv setzen: active
- Der Diskpart Teil wäre mit der Eingabe von exit geschafft.
Das ganze sieht dann z.B. so aus:
Microsoft DiskPart Version, 6.0.6002
Copyright (C) 1999-2007 Microsoft Corporation.
Auf Computer: SOLARIZ-PC
DISKPART> list disk
Datentr # Status Größe Frei Dyn GPT
- ------- ---------- ------- ------- --- ---
0 Online 1118 GB 10 GB
1 Kein Mediu 0 B 0 B
2 Kein Mediu 0 B 0 B
3 Online 7648 MB 0 B
DISKPART> sel dis 3
Datenträger 3 ist jetzt der gewählte Datenträger.
DISKPART> clean
Der Datenträger wurde bereinigt.
DISKPART> create part pri
Die angegebene Partition wurde erfolgreich erstellt.
DISKPART> sel part 1
Partition 1 ist jetzt die gewählte Partition.
DISKPART> format fs=fat32 LABEL="Windows 7" QUICK OVERRIDE
100 Prozent bearbeitet
DiskPart hat das Volume erfolgreich formatiert.
DISKPART> active
Die aktuelle Partition wurde als aktiv markiert.
DISKPART> exit
Datenträgerpartitionierung wird beendet...
Nach dieser Prozedur nur noch das ISO auf den USB Stick entpacken und davon Booten. Viel Erfolg. Ich backupe nun mal meine Daten ;>